Views: 0 Author: Site Editor Publish Time: 2026-11-19 Origin: Site
Pre-Shipment Customer Trial
A customer team joined Fuma technicians for a two-day factory test of a pneumatic wire cutter built for portioning semi-hard and high-moisture cheese into even slices and strips.
A custom pneumatic cheese cutting machine recently completed its pre-shipment trial at the Fuma workshop. Technical representatives from the customer's dairy plant in the Middle East attended the test and worked alongside our production team throughout the inspection.
The purpose of the visit was straightforward: to run the machine with cheese blocks close to the size and condition used at the customer's factory, check the finished cuts, and confirm that the equipment was practical to operate and clean before it was packed for delivery.
The trial included semi-hard yellow cheese and a softer white cheese with higher moisture content. These products behave differently during cutting. A firmer block must retain a clean edge, while a softer block is more likely to drag against the cutting element or leave material on the wire.
During the test, the wire frame moved steadily through both products. The team examined the cut faces after each run, paying particular attention to edge shape, sticking and visible product loss. The selected wire arrangement produced even slices and strips without relying on a thick blade passing through the block.

Repeated cycles were carried out during the inspection. Rather than judging the machine from a single cut, the customer and Fuma technicians checked whether the same movement and cut quality could be maintained from one cycle to the next.
Pneumatic movement: Air pressure and cylinder travel were observed through repeated strokes to confirm smooth movement under normal operation.
Wire condition: Tension was checked during the trial so that the cutting wires remained properly positioned after continuous use.
Slice and strip dimensions: Wire spacing was prepared for the customer's required cut sizes. This machine is configured for straight slicing and strip cutting rather than grid cutting or dicing.
Working height and handling: Loading, cutting and product removal were reviewed with the operators who would use the machine in daily production.
These checks allowed small operating details to be confirmed at the workshop instead of leaving adjustments until the machine reached the customer's plant.
The cutter is driven by a pneumatic cylinder and controlled through pneumatic valves. This arrangement keeps the operating method direct and avoids placing a complex electronic control system in the main cutting area.
For the customer's production team, this was important because the machine would be cleaned at the end of each shift. The stainless-steel frame, accessible cutting area and removable wire assembly make it easier to inspect product-contact surfaces and carry out routine washdown.
At the end of the FAT, the customer reviewed the cut samples, machine movement, wire change procedure and cleaning access with the Fuma team. The agreed inspection points were completed before the equipment moved to final preparation and crating.
Running the actual product before shipment gives both sides a clearer basis for acceptance. It also allows the final wire spacing and operating settings to be checked against the cheese rather than relying only on drawings or nominal dimensions.
For a similar application, the useful starting information is the cheese type, block length, width and height, product temperature, required slice thickness or strip width, and the number of blocks processed per shift. Product samples or representative test blocks can then be used to confirm the cutting arrangement before shipment.